 |
 |
| Die-Try |
| The Die-Try is used as a setup tool and for proper press and die match-up. You can know the optimal tonnage needed to make a good part with each die. The Die-Try will also alert you with alarm conditions during die tryout. |
|
 |
|
 |
| N269 |
| The N269 process control monitor provides advanced information and control for refractory, powdered metal and compaction presses. It is far more comprehensive than a typical tonnage monitor. |
|
|
|
 |
| N400 |
| The N400 Series was designed specifically for high speed applications, canning operations, compaction presses and refractory presses. |
|
|
|
 |
| PW Plus Series |
| The PW PLUS production monitors are used for many important operations, such as: automatic, progressive dies and basic stamping. It is available as a two or four channel unit for easy plant standardization. |
|
|
|
 |
| PWi |
| The PWi PressWatch Production Monitor is a four channel, cost effective full-featured monitor that interfaces with load sensors to provide force measurement for press protection and quality control. |
|
|
|
 |
| Quik-Learn |
| The Quik-Learn automatic tonnage monitor is important for die setup, SPC work, quality assurance and effective monitoring. |
|
|
|
 |
| SLIM |
| The SLIM is a signature load interface module that provides force measurement and signature analysis for critical force applications. The SLIM can interface with a wide variety of equipment from the most sophisticated PLCs and industrial computers to standard PC's. |
|
|
|
 |
| Tonnage Kits |
| A Toledo Tonnage Kit is the most cost-effective solution for adding peak tonnage to PLC systems. |
|
|
|
 |
| TTLM |
| The TTLM I/O load module is designed for critical force measurement applications where accuracy, extreme stability, and dependable noise rejection is essential. |
|
|
|
