| No. of Channels |
One, Two, Three or Four |
| Sensor Inputs |
Full bridge strain gage sensors
120 to 1000 ohms
Up to (4) 350 ohm sensors |
| Sensor Excitation |
Built-in 12VDC @ 300mA max
(Short circuit protected) |
| Sensor Input Connections |
4-pin .2" pitch Phoenix connector |
| Automatic Zero Balance |
Yes |
| Auto-Zero Time Constant |
10 Seconds |
| Balance Range |
+/- 1mV/V of offset |
| Gain Range |
Low Gain = 100-1,000x
High Gain = 1,000-11,000x |
| Analog Output |
+/- 9VDC |
| Analog Output Connection |
6-pin .2" pitch Phoenix connector |
| Peak Decay |
Less than 1% of full scale in 10 minutes |
| Accuracy |
+/- 1% of full scale max |
| Non-linearity |
+/- .1% of full scale max |
| Frequency Response |
Flat DC to 1KHz |
| Resolution |
Not Applicable |
| Strokes per Minute |
2000 SPM (probe trigger for peak capture) |
| Calibration Shunts |
1 Meg Ohm .1% precision resistor |
| Computer Interface |
No |
| Trigger |
Probe for peak capture |
| Threshold Probe |
Built-in voltage source (12VDC @ 50mA max) provides power for
NPN or PNP proximity probes. Also supports limit switch,
solid state ormechanical relays |
| Resolver Interface |
No |
| Shutdown Relay |
No |
| Power Requirements |
12 Watts max, 100-130VAC @ 50-60Hz
or 200-260VAC @ 50-60Hz
(Use 5mm x 20mm SLO-BLO fuse) |
| Expansion |
No |
| Operating Temperature |
0-70 degrees Celsius |
| Dimensions |
12.5" W x 14.5" H x 6.8" D |
| Weight |
Approximately 22.3lbs |
