| No. of Channels |
Two,Four,Six or Eight |
| Sensor Inputs |
Full bridge strain gage sensors
120 to 1000 ohms
Up to (16) 350 ohm sensors |
| Sensor Excitation |
Built-in 10VDC @ 500mA max
(Short circuit protected) |
| Sensor Input Connections |
7-pin .2" pitch Phoenix connector |
| Automatic Zero Balance |
Yes |
| Auto-Zero Time Constant |
Not Applicable |
| Balance Range |
+/- 1mV/V of offset |
| Gain Range |
100-11,000x (digitally controlled) |
| Analog Output |
1.25VDC @ Press Capacity |
| Analog Output Connection |
11-pin .15" pitch Phoenix connector |
| Peak Decay |
Not Applicable |
| Accuracy |
+/- 1% of full scale max |
| Non-linearity |
+/- .1% of full scale max |
| Frequency Response |
Flat DC to 6KHz |
| Resolution |
Each channel provides a 4-digit load value in 1024 count resolution |
| Strokes per Minute |
180 SPM (resolver trigger)
300 SPM (threshold trigger)
800 SPM (probe trigger) |
| Calibration Shunts |
Calculation based on 1 Meg Ohm shunt resistor |
| Computer Interface |
(3) RS-485 serial ports (9,600-115K baud)
10BASE-T port supports TTNet protocol |
| Trigger |
Resolver, Probe or Threshold |
| Threshold Probe |
Built-in voltage source (12VDC @ 80mA max) provides power for NPN
or PNP proximity probes. Also supports limit switch, solid state or mechanical relays |
| Resolver Interface |
Built-in excitation supports standard
5000Hz rotor excited positional resolver |
| Shutdown Relay |
8A @ 250VAC or 30VDC
N.O. Contact (N.C. Contact Optional)
External Bypass Switch |
| Power Requirements |
29 Watts max, 85-132VAC @ 50-60Hz
or 170-264VAC @ 50-60Hz
(Use .25" x 1.25" SLO-BLO fuse) |
| Expansione |
Interface port for I/O module |
| Operating Temperature |
0-70 degrees Celsius |
| Dimensions |
2.125" W x 12.0" H x 5.0" D |
