| Die Protection |
|
| Inputs |
16 |
| Sensor Type |
Momentary (1 to 50 max cycle), maintained (1 to 50 max cycle),
static NO, static NC |
| Built-in Power For Sensors |
24VDC, 750mA max |
| Tonnage Monitoring |
|
| Channels |
2 or 4 |
| Sensor Inputs |
Full bridge strain gages, 120 to 1,000 ohms, up to (8) 350 ohm sensor inputs |
| Sensor Excitation |
Built-in 10VDC @ 500mA max. (short circuit protected) |
| Automatic Zero Balance |
Yes |
| Balance Range |
+/- 1mV/V of offset |
| Gain Range |
100 to 11,000x (digitally controlled) |
| Analog Output |
1.25VDC at press capacity |
| Analog Output Connection |
.15"pitch Phoenix connector |
| Inaccuracy |
+/-1% of full scale max |
| Non-Linearity |
+/-.1% of full scale max |
| Frequency Response |
Flat DC to 6KHz |
| Resolution |
Each channel provides a 4-digit load value in 1024 count |
| Calibration Shunts |
Calculation based on 1 Meg Ohm shunt resistor |
| PLS |
|
| Outputs |
8 |
| Position Output |
Up to 2 on/off windows |
| Timed Output |
1 to 10 seconds |
| Speed Compensation |
Individual speed compensation value for each output |
| Turn on at Cycles |
Every 1 to 250 cycles |
| Mechanical Relay |
NO and NC contacts, 10 AMP @ 250VAC, 10 AMP @ 30VDC |
| Solid State Relay (optional) |
NO contact, 3 AMP @ 140VAC |
| Motion Detect |
|
| Start Time Limit |
Adjustable up to 800ms |
| SPM Limit |
Max and min limits, SPM motion output relay (same as PLS) |
| Drift Detection |
Alarm when 3 or more degrees of incorrect motion is detected |
| Dual Safety Valve Input |
110VAC mechanical relay (other voltage available) |
| Shutdown Relays |
|
| Top Stop & E-Stop |
Same type as PLS |
| HMI |
|
| Display |
Bright 6.5" diagonal TFT LCD |
| Keypad |
Menu driven, alpha-numeric |
| General |
|
| Resolver |
Built-in excitation supports standard 5000Hz rotor excited positional resolver |
| Computer Interface |
(3) RS-485/232 serial ports |
| Flash Disk |
8 MB Compact Flash |
| Power Requirements |
95 Watts max, 85-132VAC @ 50-60Hz OR 170-264VAC @ 50-60Hz |
| Operating Temperature |
0-50 degrees Celsius |
| Dimensions |
12.5"x14.5"x6.78"D |
