 |
 |
 |
These products were designed to allow maximum flexibility and to be
compatible with most control units in the industry. They are also easy to install and
inexpensive to own. |
|
EP-1 Die Mount Sensor
The EP-1 is mechanically mounted right to the die. It is
typically used to monitor the end of strip for proper feed condition
(short feed or long feed). But it may also be used to monitor the proper transfer
of parts in transfer dies, as well as detect the unwanted presence of feed apparatus
in the die area. |
|
EP-2 Magnetic Mount Sensor
The EP-2 sensor monitors the end of strip for proper feed
condition (short feed or long feed). This sensor is unique in our industry in that
it mounts anywhere in the die by using a powerful magnetic base. The base features
a quick release mechanism for easy set-up and repositioning. That’s a real plus
in quick die set changes. |
|
BP-1 Buckle Sensor
The BP-1 detects buckled material before it ever reaches the
die area which prevents accidents before they can happen. The gap between its probes
is very easy to adjust to accommodate different stock thicknesses and buckling
conditions. This sensor also has a quick release magnetic base for quick set-up
and repositioning. |
|
LS-3 Light Screen
The LS-3 consists of an infrared transmitter and receiver set
which monitors part ejection. It eliminates jammed presses and smashed dies, as
these units will not allow the press to recycle until the die area is clear. The
scanning range is 4-48" and the set can detect parts as small as a staple at high
speeds. There is no sensitivity to adjust, which is another "set-and-forget" method
for quick die changes. |
|
|
|
